The NUSCAN 2100 Series scanners are ready to scan most kinds of barcodes. This barcode scanner does not require software or drivers to operate. The scanner enters data as keyboard data. This manual should only be used to make changes in the configuration of the scanner for specific applications.
2. Introduction Bar coding is the most common Automated Data Collection (ADC) technology providing timely, error-free information that can be used to increase productivity, accuracy and efficiency in the workplace. The Charged Coupled Device (CCD) technology is a technique whereby a barcode is photographed, digitized and electronically sampled by built-in photo detectors.
Some examples are shipping and receiving, manufacturing, retail, healthcare, transportation, document processing and tracking, and libraries. NUSCAN 2100 Series Scanners can read most of the popular barcode symbologies including Code 39, Code 93, Code 128, Interleaved 2 of 5, UPC-A, UPC-E, EAN/JAN- 8, EAN/JAN-13 &...
Installation Insert the plug on the free end of the Communications Cable into the appropriate connector on the host as below described: a. USB Connection Host b. PS/2 Connection Host Test Scanning Do not hold the scanner directly over a barcode at 90˚. Scanning light bounces directly back into the scanner from the barcode label is known as specular reflection which will create a "dead zone"...
7. Scanning Mode Selection Note: The default setting of the barcode scanner is on Trigger Mode. Do not program the barcode scanner unless necessary. All program setup must start with reading the “Start” label, and reading the “End of Configuration” label to save any Start changes.
8. Beeper Mode Selection Note: The Tone and Duration default setting of the barcode scanner is on Medium. Do not program the barcode scanner unless necessary. All program setup must start with the “Start” label, and reading the “End of Configuration” label to save any Start changes.
9. Default Parameters These tables give the default settings of all the programmable parameters. DEFAULT VALUES OF OPERATING PARAMETERS Function Default Values Scanning Mode Selection Trigger mode Header and trailer None Inter-Message delay Normal Inter-Character delay Normal Message/Block mode selection Message Send command in block mode Disable...
OPERATIONAL Light Source 617 nm visible red LED Optical System 2,500 pixels CCD Depth of Field 0 up to 6 inch (UPC/EAN 100%, PCS=90%) Scan Angle 42° Scan Rate 125 scans per second 0.125 mm (5 mil) (0.1 mm actually) Minimum Bar Width (Code 39, PCS=90%) Print Contrast...
If you need to make changes in the configuration of the scanner for specific applications, a full Programming Guide can be downloaded at: http://www.adesso.com/PDF%20files/NUSCAN2100usersguide.pdf 13. Trouble Shooting a. Problem: Nothing happens when you follow the operating instructions. Possible Cause Possible Solution Interface cables are Check for loose cable connections.
• Operating System • Model number of your Adesso product • Description of how you installed and set up your Adesso product • Description of your technical difficulty Phone Support: (800) 467-1195 Before you call us for Tech-Support, please provide below information: •...