Page 1
5100 2D Manual Reset custom defaults Recall Default Recall Default Recall Default Recall Default Read the Version Number Interface mode Scan the USB Keyboard setting code to set the interface as USB keyboard. USB COM USB Keyboard) In the end application needs serial software environment, USB can be identified as a USB COM type, identified as USB COM type, users need to install the driver。...
Barcode configuration 1.UPC/EAN prohibit *Enable *Enable *Enable *Enable 2.Codabar code *Enable *Enable *Enable *Enable *No verify open verify Open verify and verify character transmission Output Starting terminator *Start and end character is not output 3.Code39code *Enable *Enable *Enable *Enable prohibit *No verify open verify Open verify and verify character transmission...
19.Trioptic Code Trioptic and PharmacodeWith only one of which is enabled, choose between one。 prohibit prohibit prohibit *prohibit Enable Enable Enable Enable 20.Codablock A Enable Enable prohibit Enable Enable prohibit prohibit *prohibit 21.Codablock F Enable Enable prohibit Enable Enable prohibit prohibit *prohibit 22.PDF417...
Page 9
Setting the Bar Code lengthBarcode set the minimum length1 Restore the factory default configuration Start/end barcode,Default then scan the bar code, and finally re-scan Start / end barcode. Start/end Default Get firmware version Trigger Release time delay settings 200ms 150ms 100ms 50ms 9 / 18...
Page 10
Operating mode Manual trigger mode IR Mode IR Mode off IR Mode open Invert the image Normal image 10 / 18...
Page 11
Aimer setting *Aimer Enable Enable Aimer prohibit prohibit Enable Enable prohibit prohibit Lighting configuration*Light Enable Enable Light prohibit prohibit Enable Enable prohibit prohibit Test Mode After you configure a test mode, the device is automatically triggered every second decoding again. Device is configured to blink test mode *Cancel the test mode is configured to blink Barcode length locking configuration...
Page 12
9. Successively sweep byte code value.… Scan "to enter / exit the programming mode." Enter / exit the programming mode Configuring Barcode Type 1 Length Configuring Barcode Type 1 byte value Configuring Barcode Type 2 Length Configuring Barcode Type 2 byte value Configuring Barcode Type 3 Length Configuring Barcode Type 3 byte value Configuring Barcode Type 4Length...
Page 13
Before adding a suffix Prefixes and suffixes Up to ten characters were added. Add the prefix process: Example 1 1, add a prefix byte character "®", ASCII code corresponding to the number of decimal 174.1. Scan"to enter / exit the programming mode" to make the device into programming mode. 2.
Page 14
Entry / exit programming mode The first one byte configuration prefix The second byte configuration prefix The third byte configuration prefix The Fourth byte configuration prefix the fifth byte configuration prefix the sixth byte configuration prefix the seventh byte configuration prefix the Eighth byte configuration prefix the ninth byte configuration prefix the tenth byte configuration prefix...
Page 15
Configuration 3rd byte suffix Configuration the first four bytes suffix Configuration the first five byte suffix Configuration the first six byte suffix Configuration the first seven byte suffix Configuration the first eight byte suffix Configuration the first ninth byte suffix Configuration the first ten byte suffix Clear all suffixes Clear all suffixes bytecode value (decimal)
Page 16
Bar code type table Barcode byte value Barcode types UPC-E EAN-8 UPC-A EAN-13 CODE 39 CODABAR INTERLEAVED 2 OF 5 CODE 128 CODE 93 CODE 11 AIRLINE 2 OF 5 MATRIX 2 OF 5 TELEPEN UK PLESSEY AIRLINE(13 DIGITS) STANDARD 2 OF 5 TRIOPTIC RSS14 RSS LIMIT...