Starting The Engine; Cutter Height Adjustment - Swisher Predator WB80024 Owner's Manual

BLADE ENGAGE
An "OPERATOR PRESENCE" bail and a "BLADE ENGAGE" lever control engaging
the Predator's blade. Both devices must be activated before the blade will work.
Releasing the "OPERATOR PRESENCE" bail will disengage both the blade and the
"BLADE ENGAGE" lever.

STARTING THE ENGINE

• See engine manufacturer's instructions for the type and amount of oil and fuel
used. Engine must be level to accurately check and fill oil.
• Make sure unit is level, blades disengaged, and transaxle in "NEUTRAL".
• Check spark plug wire, oil, and fuel.
• Turn key switch to the "ON" position.
• Set engine idle to the "CHOKE" position.
• With feet clear of cutter deck, pull engine coil rope. Do not pull rope recklessly.
• Set engine speed by moving "CHOKE" to the desired RPM.
STOPPING
• Bring cutter to a complete stop.
• Disengage the blade.
• Place transaxle in the "NEUTRAL" position.
• Turn key to "OFF" position.
• Remove keys to avoid irresponsible usage.

CUTTER HEIGHT ADJUSTMENT

• There are two height settings.
• Place two 6" wooden blocks under the deck on the side being adjusted.
• Remove nuts and bolts from the side runner.
• Slide runner to the other position.
• Replace the nuts and bolts making certain they are secure.
• Repeat to other side. Runners should be at the same height.
BREAKING IN YOUR CUTTER
• Start engine properly.
• Slowly, engage blade control.
• Under supervision, allow blades to rotate and engine to idle for 5 minutes.
• Disengage blades.
• Shift through each gear. While in each gear engage the "GROUND CONTROL"
and travel 20 yards to ensure transaxle works properly.
CAUTION!
Disconnect spark
plug wire and place
the wire where it
cannot connect the
spark plug before
servicing unit.