Page 2
Installation: The WPT-3000 transmitter is used with the Dakota Alert WR-3000 receiver. The WPT-3000 transmitter uses a magnetic probe and 50 feet of direct burial cable to detect vehicles at the monitored location.When the transmitter detects a vehicle it will send a signal to the receiver...
Page 3
Coding the transmitter: 1. Locate the dip switches in the WPT-3000 transmitter. 2. The first 8 dip switches are for the frequency setting (256 combinations) (figure 1). Set the first 8 switches to match the 8 switches in the receiver.
Page 4
3. Switches 9 & 10 are for the zone/channel Switch Switch Channel 12-volt Tune setting on the transmitter (Figure 1). DC output The four zones are as follows: (see table Classical at right) Off Westminster Mounting the transmitter: Off Ding Dong 1.
Page 5
Coding the receiver: figure 2 1. Open the receiver case by inserting a small screw driver into one of the pry notches on the side of the case. (refer to receiver manual) 2. Gently lift off the front cover. 3. Locate the 8 dip switches on the receiver and make sure they are set identically to the first 8 dip switches on the transmitter.
Page 6
Troubleshooting the WPT-3000 Although the WPT-3000 should be very reliable, there are occasions when you might have false alarms or a failure to alert. If you are getting false alarms, please try this: • Make sure that the probe is at least 50 feet from any main roads.
WARRANTY Dakota Alert warrants this product to be free of defects in material and workmanship for a period of one year from the date of purchase. This warranty does not cover damage result- ing from accident, abuse, act of God or improper operation.
Page 8
Dakota Alert, Inc. 109 W. Main Street P0 Box 130 Elk Point, SD 57025 Phone: (605) 356-2772 Fax: (605) 356-2584 Web: www.dakotaalert.com...