Programming Device Control - Universal Electronics ATLAS CABLE 4-DEVICE User Manual

Atlas Manual rev2 E/Sp
INSTALLING BATTERIES (continued)
2. Obtain two (2) new AA alkaline batteries.
Match the + and – marks with those in the
battery case, then insert the new batteries.
3. Align the cover's keys with the case's holes and
press the cover back into place. The tab should
click when the cover is locked.
4. Test the unit by pressing POWER and any mode
key (e.g., TV). If batteries are inserted correctly,
the selected mode key will blink once.
NOTE: When batteries need replacement, the remote control will
cease to operate. Replace the batteries and the unit will be restored
to its full functionality, complete with your favorite settings.

PROGRAMMING DEVICE CONTROL

The Atlas Universal Remote Control is preprogrammed to
operate the cable converter provided by your cable system,
an RCA TV, an RCA VCR, and a Pioneer audio receiver.
To control devices other than the default brands, perform
the following steps; otherwise skip this section:
NOTES: To control a DVD player, program the VCR key. To control
a PVR, program the VCR key. To control a stereo amplifier or
receiver, program the AUD key. For TV/VCR Combo control, skip
this section and perform the instructions on page 10.
If you have another brand of cable converter and interactive
service you would like to control, you'll first need to unlock the
cable ID Lock before changing the converter code – see
"Programming ID Lock" on page 13.
1. Turn on a device and, if applicable, insert video
media, (e.g., cassette or disc).
NOTE: Please read steps 2 to 4 completely before pro-
ceeding. Highlight or write down the codes and device
you wish to program before moving on to step 2.
2. On the remote control, press a device key once
(e.g., AUD, VCR, TV, or CBL). Press and hold
SETUP until the selected mode key blinks
twice, then release SETUP.
3. Use the Manufacturer's Codes (starting on
page 42) to locate the the type of device and
brand name and then enter the first four-digit
code for your device. If performed correctly, the
selected mode key will blink twice.
5/8/03 5:18 PM Page 8
8