Samsung SND-3080P User Manual page 67

To set the motion detection function
1. Select <Event> - <Motion>.
The Motion Detection setup window
appears.
2. When done, click [Apply].
Your settings will be saved.
M.D. function : If selecting <Enable>,
the motion detection function will be
activated; if selecting <Disable>, it will
not operate at all.
M.D. confi guration : Confi gure the
motion detection settings.
- Motion sensitivity : Select one from
<High>, <Medium> and <Low>.
Selecting <High> will trigger the motion detection event even with a small motion.
- Motion area : Set an area where the motion detection is performed.
Activation time : Set the time to activate a specifi ed operation when a motion is
detected.
- Always : Always executes the specifi ed command when a motion is detected.
- Only scheduled time : Executes the specifi ed command when a motion is
detected only on a specifi ed weekday, or time.
Action : You can set an action to execute when a motion is detected.
- Alarm output : Set the alarm output port to which the motion detection signal is
transferred.
- Output duration : Set the period of time to output the motion detection signal to the
specified alarm output port when a motion is detected.
If another motion is detected during the alarm output, the delay time is recalculated
based on the detection time of the recent motion.
- Alarm image transfer : If you select <On>, you can transfer JPEG images to a
registered address via FTP or SMTP server or save images into the SD memory card
according to the setting in <Event> - <Transfer setup>.
English _67