Samsung SND-3080P User Manual page 65

To set an alarm image
You can configure to send message via FTP/E-mail (SMTP) or to save recording into the
SD memory card.
Select a transfer method when an event occurs or the schedule transfer function is
activated.
1. Select <Event> - <Alarm image>.
The Alarm Image setup window
appears.
Transfer mode : You can select
alarm message notifi cation method
among FTP/E-mail transfer and SD
Card recording.
- FTP transfer : The image is sent to
the specifi ed FTP address.
- E-mail transfer : The image is sent to the specifi ed email address.
- SD Card Record : Saves images into the SD memory card.

M
If an SD memory card is not inserted, the corresponding button will be disabled.
In this case, insert the SD memory card into the slot and refresh to enable the button.

J
If the SD memory card is ejected while the button is checked, the camera automatically
restarts.
Transferred image naming setup : You can set the fi le name of an alarm image
to be sent when an alarm is triggered or during the scheduled transfer.
Pre/post alarm image : You can set to save the pre or post alarm image.
- Number of image : The frame rate per second can be one among 1, 2, 3, and 5.
- Pre-alarm duration : The pre alarm duration can be one among 5 seconds, 10
seconds, 15 seconds, and 30 seconds. You can send a pre-alarm image of up
to 30 seconds before the alarm is triggered.
(The max time differs, depending on the frame rate)
- Post-alarm duration : The post alarm duration can be one among 5 seconds, 10
seconds, 15 seconds, and 30 seconds. You can send a post-alarm image of up
to 30 seconds after the alarm is triggered.
(The max time differs, depending on the frame rate)

M
The pre/post alarm duration is not available in SMTP transfer mode.
Only one image at the corresponding time will be transferred.
2. When done, click [Apply].
Your settings will be saved.
English _65