Samsung SND-3080P User Manual page 89

PROBLEM
I enabled Motion Detection Feature
under Motion Detection, but .jpg
files are not getting sent over FTP/
SMTP even after motion detection
occurs at the FT camera.
Is it possible to configure Motion
Zone with Motion Detection
Feature disabled?
A motion event took place but
didn't trigger an alarm.
Cannot record into the SD memory
card.
SD memory indicator does not
turn on even when the SD memory
card is inserted.
SD memory card is inserted but
the camera does not operate
properly.
Cannot format the SD memory
card.
Verify the settings in the following sequence:
A. NTP must be properly configured.
B. Motion Detection Feature must be enabled.
C. Alarm Video Transmission must be enabled.
D. Check for scheduling conflict.
Yes. Motion Zone can be configured independently of whether or not
Motion Detection Feature is in use.
Check alarm output port settings.
Check if the memory card is defective.
Check if the write protection tab of the memory card is set to "Lock".
Check if the memory card is defective.
Check if the <Record> is checked in <Setup>
Record> menu.
Check if the memory card is inserted in the proper direction. Operation
of memory card that is formatted by other devices is not guaranteed
with this camera unit
Format the memory card again in <Setup>
menu.
Check if the write protection tab of the memory card is set to "Lock".
SOLUTION
<Event>
<Event>
<SD Card
<SD Card>
English _89