Configuring Osd Settings - HIKVISION HK-RA208 Series User Manual

2. Select the camera to setup video loss detection in using the camera drop down menu on the upper left of the
menu. If all cameras are to be configured with the same settings, select All Cameras from the list.
3. Click Enable Video Loss Detection.
4. Select Actions to take if video loss is detected. More than one action can be selected per channel. These
actions include:
• Sound Audio Warning: DVR will sound an audio warning if video loss is detected.
• Pop-up Image on Monitor: DVR will show the corresponding channel that is associated with the video
loss channel.
• Notify Surveillance Center: DVR will notify surveillance center when video loss is detected.
• Send Email: DVR will send an email out to the designated recipients when video loss is detected.
• Trigger Alarm Output: DVR will trigger alarm output when video loss is detected. Selecting this option
will enable the Alarm Output list, where the output to trigger can be selected.
5. Select the Save button to save the privacy zones settings and select Exit to return to the previous menu.
Selecting the Exit button without clicking Save will quit out of the menu without saving settings.

Configuring OSD Settings

On Screen Display (OSD) settings can be configured in the OSD Configuration menu. The OSD is shown in each
display in Live Feed and Playback mode.
To configure OSD settings:
1. Enter the OSD Configuration menu, shown in Figure 51 by going to Main Menu > Cameras Setup > OSD
Configuration.
Hikvision USA, Inc. – Series HK-RA208/216 User Manual
Figure 50. Video Loss Detection Menu
55