Connecting The Receiver - Triax C-HD207 User Manual

Connecting the receiver

Connecting the receiver
RF connection
Connect the RF Input Digital connector (6) of the receiver to your cable signal wall socket.
Connecting a television
Use a scart cable to connect the TV connector (3) on the receiver to the corresponding scart
connector on the television set.
HDMI output (4)
If your receiver is connected to the TV by a HDMI-cable, audio- and videosignal are digital.
Connecting a digital multi-channel amplifier (optional)
The receiver is optionally available with an AUDIO OUT connector (8) for a DOLBY DIGITAL
signal. Use a suitable cable to connect this connector to your multi-channel amplifier.
Connecting an external IR receiver (optional)
If you want to set up the receiver where it can't be seen, you can connect a so-called IR
mouse to the RJ-11 connector (9). This must be positioned in such a way that it can receive
the signals from the remote control. When installing the receiver, always be sure to follow the
safety and installation instructions.
Connecting an external mass storage device (optional)
For recording of TV programmes, an external mass storage device can be connected to the
optional USB-connector (5).
Connecting the mains adaptor
Connect the DC plug of the mains adaptor supplied with the unit to the connector DC-INPUT
+12V (2) on the receiver.
How to insert batteries into the remote control
Open the cover at the rear side of the remote control.
Insert two AAA type batteries (1.5V).
Attention: Take care of appropriate +/- polarity!
Note:
If the operational range of the remote control is getting smaller, it indicates that the batteries
are almost consumed. Always replace both batteries.
Caution:
Do not heat, disassemble or recharge the batteries.
Consumed batteries are not allowed to be disposed in domestic refuse. They must be supplied
to a facility, collecting and disposing exhausted batteries according to the EU environmental
protection rules.
6