Trouble-Shooting - Triax C-HD207 User Manual

Trouble-shooting

Every electric device can have a malfunction. It does not automatically mean that it is
defective. In most cases it happens because of a feed cable, plug-and-connector connections
or access mistakes. Please control the following items before taking the receiver to your
specialised dealer:
Problem
Receiver can not be
turned ON
No or bad picture
No audio
Remote control does
not work
Time is displayed
wrongfully
Timer is activated at the
wrong time
No picture,
Channel change
screen graphic shows
"No valid signal!"
Possible causes
Mains adapter not connected to
mains
Batteries of the remote control
are not inserted / inserted faulty
TV set is running on wrong
channel
Scart or HDMI cable is damaged
or plugged in incorrectly
Volume is set too low
Cable damaged or plugged in
incorrectly
Distance to big
Batteries are exhausted or
inserted incorrectly
IR receiver is covered or not
reachable by the IR signal
Timer is activated
Difference between local time
and GMT is set incorrectly.
Difference between local time
and GMT is set incorrectly.
Cable is defect or plugged in
on incorrectly
Channel has changed frequency
Incorrect Settings in menu
„Settings"
Help, Tips
Check if mains adapter is
plugged in correctly.
Try another electric device at
the same power connector.
Check batteries
Check set up of the TV set
Replace or plug in the Scart or
HDMI cable correctly
Increase volume
Check cable and ports
Come closer to receiver, point
remote control directly towards
receiver
Insert batteries correctly
Remove barriers between
remote control and receiver
Deactivate timer
Enter menu Receiver setup and
set time difference correctly
Enter menu Receiver setup and
set time difference correctly
Check cable and ports
Perform channel search
Correct settings or restore the
factory default status
30
Trouble-shooting