Printer Limitations - Ricoh DDP70E-92 User Manual

Printer Limitations

The following types of paper are printed from the MBT only with PCL.
Transparency
Pre-punched Transparency
Label
The following paper types will print simplex even if duplex is specified.
Transparency
Pre-punched Transparency
Label
Tab Stock
Duplex printing cannot occur when the paper source is the MBT.
The printer does not staple a single page job.
The following paper types are jogged even if staple is specified.
Transparency
Pre-punched Transparency
Label
When errors such paper jams or paper empty occur during printing, print
performance may be reduced after the errors are cleared.
The MBT cannot be included in PCL Tray Auto Select. If the MBT is included,
printing will stop and the OCP will prompt you to load the correct paper size to
the MBT (even when paper is already loaded in the MBT).
When the Finisher runs out of staples the action will reflect the setup defined in
the Web Utilities (System/Finisher)
Stop: Error message will appear on the OCP.
Continue: Printing will occur with job offset.
If stapling is requested, the job will be delivered offset with no stapling under the
following circumstances: If the staple job contains more than 50 sheets, if the
thickness of the paper is more than 5.0 mm, or if the paper weight is over 34 lbs.
If stapling is specified but not collating, the job will not be stapled.
When stapling and face-up delivery are both specified, the job will be delivered
face up and offset with no stapling.
5-16 Troubleshooting