Test Run - Grizzly G0503 Instruction Manual

Test Run

Before starting the resaw, perform the pre-
ceding assembly and adjustment instruc-
tions, and read and understand the entire
manual. failure to follow this warning could
result in serious personal injury or death!
To test run the resaw:
1.
Make sure the wheel cover is closed and all
tools or other objects are cleared away from
the resaw.
2. put on safety glasses and hearing protection,
and make sure any bystanders are wearing
safety glasses and hearing protection and
are out of the way.
3. turn the EMg stop switch (shown in figure
24) clockwise until it pops up.
figure 24. power switches.
Model g0503 (Mfg. since 12/08)
4. turn the powEr on switch (shown in
figure 24) clockwise.
5. press the Motor start button and imme-
diately press the EMg stop button. as you
are standing in front of the machine, make
sure that the blade is moving from left to
right.
— if the blade is moving the wrong direction,
swap the incoming power supply wires at
the R and T locations on the main termi-
nal block inside the electrical cabinet—
this will reverse the blade direction.
— if the blade is moving in the correct direc-
tion go to step 5.
5. turn the EMg stop switch clockwise until
it pops up. press the Motor start button
again.
— if any problems occur, immediately
press the EMg stop button. turn to
Troubleshooting on page 68 and correct
the problem before operating the machine
further.
— if you cannot easily locate the source of
an unusual noise or vibration by yourself,
please contact our service department at
(570) 546-9663.
6. press the puMp start button. push the
conveyor lever forward to test the conveyor
belt. if the conveyor belt does not turn after
pushing the conveyor lever forward, rotate
the conveyor speed knob counterclockwise.
— if any problems occur, immediately
press the EMg stop button. turn to
Troubleshooting on page 68 and correct
the problem before operating the machine
further.
— if you cannot easily locate the source of
an unusual noise or vibration by yourself,
please contact our service department at
(570) 546-9663.
-25-