Table of Contents
Advertisement
positioning the
control panel
Tools Needed
hex wrench 8mm ............................................ 1
To mount the control panel:
1.
unwrap the protective covering from the con-
trol panel and support arm.
2.
place the control panel support arm into the
mounting bracket as shown in figure 14.
Cap screw
Cap screw
figure 14. Control panel assembly.
3.
position the control panel for easy access,
as shown in figure 15, and tighten the cap
screws shown in figure 14.
figure 15. Control panel positioning.
Model g0503 (Mfg. since 12/08)
Qty
Tools Needed
wrench/socket 17mm ...................................... 1
To mount the return rollers:
1.
Mounting
Bracket
2.
3.
Mounting the
Return Rollers
remove all four bolts shown in figure 16.
figure 16. return roller mounting bolts.
get assistance and lift the rollers into the
position shown in figure 17.
thread the bolts with washers through the
return roller holes and into the resaw.
figure 17. return roller placement.
Qty
-21-
Advertisement
Table of Contents
