Table of Contents
Advertisement
4.
to raise the left side, loosen the lock nuts
on the conveyor adjustment bolts on the left
side and tighten the adjustment bolts. do
the same procedure to the right side bolts to
raise the right side.
5.
tighten the lock nuts on the adjustment bolts
and tighten the conveyor mounting bolts.
6.
Connect the resaw to the power, and repeat
steps 1 and 2.
—if the measurements are close to correct,
but need fine tuning, continue to step 6.
—if large adjustments are necessary, repeat
steps 3 and 4.
7.
loosen the cap screw shown in figure 61.
figure 61. Conveyor fine adjustment.
8.
the adjusting nut shown in figure 61 raises,
or lowers, the non-drive side of the bandsaw
blade (the side opposite the motor). insert the
pry tool into the adjusting nut.
—rotate the adjusting nut to the right to raise
the bandsaw blade.
—rotate the adjusting nut to the left to lower
the bandsaw blade.
9.
retighten the cap screws, connect the resaw
to the power, and repeat steps 1 and 2.
—if the measurements are close to correct,
but need fine tuning, continue to step 6.
—if large adjustments are necessary, repeat
steps 3 and 4.
Model g0503 (Mfg. since 12/08)
adjusting nut
Cap screw
To adjust the conveyor table front to back:
1.
Disconnect the resaw from the power
source!
2.
place two flat bars of wood or metal under
the conveyer belt as shown in figure 62.
figure 62. Checking table alignment.
3.
place a square against the surface of the
wheel and slide it up against the bars on the
conveyor table.
— if the square touches both bars, no adjust-
ment is necessary.
— if the square touches the front bar, but
not the back bar, the front of the conveyor
needs to be raised. go to step 4.
— if the square touches the back bar, but
not the front bar, the back of the conveyor
needs to be raised. go to step 4.
4.
loosen all six of the conveyor mounting
bolts.
5.
to adjust the tilt, loosen the lock nuts on the
conveyor adjustment bolts on the end that
needs to be raised and tighten the adjust-
ment bolts until the square touches both
bars.
6.
tighten the lock nuts on the adjustment bolts
and tighten the conveyor mounting bolts.
-45-
Advertisement
Table of Contents
