Table of Contents
Advertisement
Replacing conveyor
To replace the conveyor belts:
1.
start the conveyor belt and stop it when
the conveyor belt seam (see figure 64) is
accessible.
figure 64. Conveyor belt seam.
2.
Disconnect the resaw from the power
source!
3.
loosen the roller bracket by turning the roller
bracket cap screws
4.
loosen the rear adjustment nuts away from
the bracket plate.
5.
Mark the front adjustment nut with a felt-
tipped pen or a piece of tape, and thread
the front adjustment nut all the way up, while
keeping track of the number of full turns that
you moved the nut.
note—Write the number of turns down, so
you do not forget. Remembering this number
is an important part of the re-assembly pro-
cess.
Model g0503 (Mfg. since 12/08)
of a turn (figure 63).
⁄
3
4
6. slide the roller brackets toward the body of
the resaw to loosen the belt.
7. remove the stiff cable from the center of the
seam to separate the conveyor belt.
8. remove the old conveyor belt from the con-
veyor table, and install the new conveyor belt
in its place.
9. Mesh the seam "teeth" together on the new
belt, and insert the stiff cable into the center
of the seam to lock it together.
10. slide the roller brackets away from the body
of the resaw to tighten the belt.
11. thread the front adjustment bolts the same
number of turns as in step 5.
note—The new belt may be tighter than the
old one because it has not been broken-in. If
this is the case, deduct one or two turns from
your original number of turns.
12. run the conveyor belt to check the tracking.
if the belt starts tracking to one side, stop the
resaw and perform the "Tracking Conveyor"
instructions that are located on page 46.
-47-
Advertisement
Table of Contents
