Using The Lock; Error Codes - Schlage CO-200 Instruction Manual

After credentials have been programmed, present credentials to operate the lock as follows:
Credential Type
Present credential to reader 
Credential
Present credential
+ PIN Credential
to reader 
1 If the PIN is entered incorrectly, press "
2 The "#" key is used as ENTER key for PINs with fewer than the minimum number of digits. Default minimum digits
is six (6). This can be confi gured with the HHD, so users do not have to push the "#" key.
All error codes are indicated on the Schlage button by a solid red LED and a blinking green LED.
The number of green blinks indicates the error code.
Number of
Green Blinks
1 Computer programming error (not complete).
2 Too long user/master code entered. Code length cannot exceed 8 digits.
3 Memory full, too many codes. Delete some codes.
4 Master code cannot be deleted, only changed.
5 Master code entries do not match. Master code not changed.
6 Invalid command. Invalid function code entered.
7 Code not found.
Code too short. Minimum master code length is fi ve (5) digits, minimum user code
8
length is three (3) digits.
9 Not a unique code.
10 Manual programming not allowed.
Error code functions have not been verifi ed by Underwriters Laboratories Inc.

USING THE LOCK


1
Press PIN
" to start over.
*

ERROR CODES

Error Code Description
9
CO-200 Offl ine Lock User Guide
Action
Green blink and access granted
Within 5 seconds,
2

Press
Green blink and
access granted