Focus Adjustment; Connect The Monitor; Programming; Setup Menu - GE UVD-EVRDNR(-P) User Manual

Focus adjustment

To adjust the camera zoom and focus, see Figure 5 below and do the following:
1. Loosen the zoom ring thumbscrew.
2. Turn the zoom ring to set the desired zoom.
3. Tighten the zoom ring thumbscrew.
4. Loosen the focus ring thumbscrew.
5. Turn the focus ring to set the desired focus.
6. Tighten the focus ring thumbscrew.
Figure 5: Zoom and focus adjustment
Zoom ring thumbscrew for VA2 and focus ring for VA9 lens

Connect the monitor

Program the cameras by attaching a standard video monitor to the system.
To connect the monitor, do the following:
1. Plug the monitor output cable (Figure 2 on page 5) to the video monitor output
connector (Figure 1 on page 5).
2. Connect the BNC cable to the video monitor.
3. Press Enter (see OSD control pad on page 9) to display the Setup menu.

Programming

This chapter describes how to navigate the programming menus to adjust the
camera settings.

Setup menu

To access the Setup menu (Figure 6 on page 9), do the following:
• To navigate to a menu item, press Up, Down, Left, or Right (Table 1 on page 6).
• To select the item for adjustments, press Enter.
• To display the submenu for the selected item, press Enter.
There is a menu map provided on the back page of the manual.
8
Focus ring thumbscrew for VA2 and zooming ring for
VA9 lens
UVD-EVRDNR(-P) Camera User Manual