Table of Contents
Advertisement
UART2 Mode
The field allows you to specify the operation mode for serial port "COM B".
Settings are:
Standard:
HPSIR :
ASKIR :
IR Function Duplex
The field specifies a duplex value for the IR device connected to COM B. Full
Duplex mode permits silmutaneous two-direction transmission. Half Duplex
mode permits transmission in one direction only at a time. Settings: Half and
Full.
TX, RX inverting enable
This item allows you to enable the TX, RX inverting which depends on
different H/W requirement. This field is not recommended to change its
default setting for avoiding any error in your system. Settings: "No, No",
"No, Yes", "Yes, No" and "Yes, Yes."
Onboard Parallel Port
This specifies the I/O port address and IRQ for the onboard parallel port.
Settings: 378/IRQ7, 278/IRQ5, 3BC/IRQ7 and Disabled.
Onboard Parallel Mode
This item selects the operating mode for the parallel port: Normal, EPP, ECP or
ECP/EPP.
ECP Mode Use DMA
The item specifies the DMA channel 1 or 3 for the parallel port when it is set to
ECP or ECP/EPP mode.
Parallel Port EPP Type
The item selects the EPP version used by the parallel port if it is set to EPP or
ECP/EPP mode. Settings: EPP1.7 and EPP1.9.
RS-232C Serial Port
IrDA-compliant Serial Infrared Port
Amplitude Shift Keyed Infrared Port
3 - 2 1
®
AWARD
BIOS Setup
Hide quick links:
Advertisement
Table of Contents
