Table of Contents
Advertisement
SEQUENCER MODULE
EDIT 5 – REASSIGN PRESET
You may re-assign a different Preset to a previously recorded track at any time
with this command.
1. With the EDIT module active, key in 5. The display says:
Track Presets
Use Sliders A&D
2. Slider A catalogs the tracks you have recorded. The top line of the display
shows the track number; the bottom line shows the Preset assigned to that track.
Slider D catalogs the available Bank Presets. When the display confirms your
choice of track and Preset, hit ENTER and the Preset will be re-assigned.
EDIT 6 – APPEND SEQUENCE
This function appends the Bank Sequence of your choice on to the end of the
Current Sequence. You may also append a Sequence to it self.
1. With the EDIT sub-module active, key in 6. The display says:
Append Seq#
(01 – 99)/Slider A
2. Either use the keypad to specify the Sequence number, or move Slider A to
catalog (see GENERAL INSTRUCTIONS 7, "Cataloguing") the available Bank
Sequences. When the display shows the Sequence you want to append, press
ENTER. The display now says:
Append Seq#
You Sure? Y/N
...where XX is the Sequence number you just specified. Press YES to append
the Sequence then return to the Module Identifier, or press NO to return to the
Module Identifier without appending the Sequence.
Note: Once a Sequence has been appended, it cannot be "unappended".
Therefore, before appending we recommend making a copy of the Current
Sequence as a "back-up".
Caution: When appending a Sequence, make sure that the controllers assigned
to the two Sequences match up.
© 1985, 1986, 1987 E-mu Systems, Inc.
XX
Page 193
Advertisement
Table of Contents
