Edit 4 - Store Controls - E-Mu EII+ Owner's Manual

SEQUENCER MODULE

EDIT 4 - STORE CONTROLS

This function lets you store control source changes along with a track. You may
store as many control source changes as desired with a track, however, the same
control source cannot be assigned to more than one track. For example, if you
store control source 1 (pitch bend) on one track you cannot store pitch bend
information on any other track. Please note that storing control settings uses up a
lot more memory than simply storing note information.
1. First select the Preset you want to record, and then use SETUP 1 ("Select
Track") to select the track on which you want to record. The controller must be
enabled in the Current Preset or nothing will happen.
2. Before recording, activate the EDIT sub-module and key in 4. The display says:
RecTrk#X
Real Time (1 – 7)
...where X is the track to be recorded. Enter the number(s) corresponding to the
control source(s) you want to store, as listed in the Real Time Control module
(1=Pitch, 2 = Filt Fc, 3=Level, and so on). After the display confirms your choice,
press ENTER Note: If you select a control source which has already been
assigned to a different track, the display will say "AssignedToTrk#X" where X is
the track number to which the control source was previously assigned.
3. Press RECORD and then PLAY. As you record, the control source changes will
be stored along with the track.
© 1985, 1986, 1987 E-mu Systems, Inc. Page 192