Control 3 - Function: Level; Control 4 - Function: Lfo To Pitch - E-Mu EII+ Owner's Manual

REALTIME CONTROL MODULE

CONTROL 3 - Function: LEVEL

1. To assign overall level to the control source (selected as per GENERAL
INSTRUCTIONS 6), key in 3.
Application: Probably the most common use is to assign LEVEL to the footpedal, thus
giving footpedal-controlled volume. Or, assign this destination to the Right wheel when
you need a manual volume control (such as during fadeouts).
Assigning LEVEL to the Left wheel can also be useful. At center position, the volume
level is audible but can be increased by rotating the wheel away from you. Rotate the
wheel towards you to fade out the sound completely.

CONTROL 4 - Function: LFO to PITCH

1. This function controls the extent to which the LFO modulates pitch (VIBRATO DEPTH).
To assign this destination to the control source (selected as per GENERAL
INSTRUCTIONS 6), key in 4. (To change the LFO rate and LFO variation, refer to
sections VCA/LFO 2A and 2C.)
Application hint: This destination is most often assigned to the Right wheel; rotating the
wheel away from you increases the amount of vibrato. Assigning this destination to the
footpedal provides foot-controlled vibrato.
Note: This function is operative only if Voice Definition function 23A is set at 00.
Otherwise, Vibrato Depth in the Voice Definition module has priority over the wheel-
assigned LFO to PITCH.
© 1985, 1986, 1987 E-mu Systems, Inc. Page 164