Table of Contents
Advertisement
SEQUENCER MODULE
SETUP 2 - Function: TEMPO
This function sets the Sequence tempo. Tempo may be changed at any time;
therefore, you can record a complex part at a slower tempo, and then bring the
speed up to normal during playback.
1. With the SETUP sub-module active, key in 2. If you are calling up this function for
the first time, the display shows the default tempo setting:
Tempo:
Use Slider A
2. Choose a tempo in the range of 40 to 240 Beats Per Minute with Slider A. Note
that the tempo moves in 1 BPM increments from 40 to 120 8PM, 2 BPM
increments from 120 to 162 BPM, and 3 BPM increments from 162 to 240 BPM.
Tempo is recorded as part of the Sequence.
3. To continue with the setup process, select the next function (SEQUENCER
SETUP 3). To return to the Module Identifier, press ENTER.
SETUP 3 - Function: AUTO CORRECT
This command does not, as some people think, tune up your car. Instead, it does
something much more important: It optionally "rounds of f" the notes you play to
a specified rhythmic value, thus eliminating timing errors. It also lets you set the
metronome to one of six different rhythmic values.
1. With the SETUP sub-module active, key in 3. If you are calling up this function for
the first time, the display shows the default auto correct and metronome settings:
Auto Corr = HiRes
Metronome 1/4
2. Slider A selects one of the following auto correct values:
1/4
every note you play will be rounded off to the nearest quarter note
1/4 t
every note you play will be rounded off to the nearest quarter note triplet
1/8
eighth note
1/8 t
eighth note triplet
1/16
sixteenth note
1/16 t sixteenth note triplet
1/32
thirty-second note
1/32 t thirty-second note triplet
HiRes notes you play are all rounded off
© 1985, 1986, 1987 E-mu Systems, Inc.
120BPM
Page 184
Advertisement
Table of Contents
