Zte MF612 User Manual page 27

BSSID: MAC address of the Wi-Fi.
Frequency(Channel): Choose the appropriate channel to optimize
the performance and coverage of your wireless network.
WDS Mode: WDS enable router to communicate with other APs,
WDS connection is two-way communication, APs should know each
others wireless MAC address. And make sure that all APs share the
same SSID and channel.
WDS configuration is shown below:
Step
1. Set the same SSID and
channel for APs
2. Select WDS mode:
Disable, Lazy Mode,
Bridge Mode or Re-
peater Mode
3. Select Phy mode:
CCK, OFDM, HTMIX or
GREENFIELD
4. Select Encryp Type:
WEP, TKIP, AES
5. Set peer AP's wireless
MAC address on router
Description
Manually set the SSID and channel is
strongly recommended
If you select Disable, WDS is disabled.
If you select Lazy Mode, WDS is enabled,
and set wireless MAC address only on
the peer APs.
If you select Bridge Mode, WDS is
enabled, and set the peer APs wireless
MAC address on router.
If you select Repeater Mode, WDS is
enabled, and set the peer APs wireless
MAC address on router.
-
If you select NONE, all the data transmitted
without encryption, and other station can
access router.
Only Repeater Mode and Bridge Mode
need this.
Internet Access
27