Turning On Your Player - Gateway Connected DVD Player User Manual

3
If the player's network card is a wired Ethernet card, connect one end of an Ethernet
cable to the network card, then connect the other end to an Ethernet jack on your
existing network.
4
After you connect video and audio cables and install the network card, configure your
video by following the instructions in

Turning on your player

To turn on your player:
1
Make sure that your computer is on and running Media Server, your home network
is set up, and all audio and video devices are turned on.
2
Connect the player's power cord to a wall outlet, then press the
the front of the player. The LED in the POWER button turns green.
3
Turn on your TV.
4
Turn on any video device the DVD player is connected to, then use the video device's
controls to set it to the audio/video input type connected to the player.
5
Turn on any audio device the DVD player is connected to, then use the audio device's
controls to set it to the audio input type connected to the player.
22
"Turning on your player" on page
www.gateway.com
22.
button on
POWER