Table of Contents
Advertisement
REMOVING THE ELECTRONIC OVEN CONTROL
WARNING
Electrical Shock Hazard
Disconnect from electrical supply before ser-
vicing unit.
Failure to do so could result in death or
electrical shock.
CAUTION: When you work on the range, be
careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
1.
Turn off the electrical power to the range.
2.
Remove the knobs from the controls.
Refer to Figure 4-2 for the following steps.
3.
Unsnap the two clips at the inner control
locations and lift the front edge of the
control panel glass, then slide the top
edge of the glass out of the control panel
flange, and remove it.
& THE CONTROL PANEL
4-2
4.
To remove the electronic oven control:
a) Remove the two screws from the be-
zel and window and remove them from
the control panel.
b) Remove the two screws from the
bracket, lift the electronic oven control
assembly off the control panel, and ro-
tate it back so you can access the con-
nectors.
c) Disconnect the three connectors from
the electronic oven control (see the
inset).
5.
To remove the control panel:
a) Remove the two top screws and the
two side screws in the end caps from
the control panel.
b) Open the oven door and remove the
three bottom screws.
c) Remove the control panel from the
range by pulling it forward and lifting it
at the front.
d) To remove an end cap, remove the two
mounting screws (1 top & 1 bottom).
Hide quick links:
Advertisement
Table of Contents
