Whirlpool 4322525 Manual page 54

PROBLEM
Cooktop element will not heat
higher than low-medium.
Cooktop element heats up nor-
mally, but drops to lower setting
automatically.
Indicator light does not light up.
Hot surface indicator light does
not work.
Oven light fails to operate.
Door locks but indicator lights do
not light. Oven does not begin
clean cycle.
Electronic timer will not accept
programming.
Timer relay(s) do not close.
Oven will not bake (selection is
set for to BAKE).
Oven will not bake (selection is
set for TIMED BAKE).
POSSIBLE CAUSE
Low line voltage.
Defective cooktop element.
Customer using improper cookware.
Defective cooktop control switch.
Loose or bad wiring to indicator
light.
Defective indicator light.
Defective cooktop control switch.
Loose or defective light.
Loose or bad wiring to indicator
light assembly.
Bulb burned out.
Circuit breaker or fuse is open.
Defective switch.
Defective indicator light.
Defective latch safety switch.
Failed electronic board.
Loose or bad wiring to timer.
Failed electronic board.
If indicator light lights up bake
element is defective.
Defective latch safety switch.
Loose or bad wiring.
Defective electronic clock.
6-2
SOLUTION
Line voltage should be minimum
240-volts. Electrician should re-
pair cause for low line voltage.
Test and/or replace element.
Evaluate suitability of cookware.
Test and/or replace switch.
Repair or replace wiring (see
wiring diagrams).
Replace indicator light.
Test and/or replace switch.
Replace indicator light.
Replace indicator light assembly
and wiring.
Replace bulb.
Check circuit breaker or replace
fuse.
Check continuity and/or replace
switch.
Replace indicator light.
Replace switch.
Replace timer.
Repair or replace wiring (see
wiring diagrams).
Replace timer.
Check and/or replace bake ele-
ment.
Check continuity and/or replace
switch.
Repair or replace wiring (see
wiring diagrams).
Check continuity and/or replace
clock (see wiring diagrams).