Whirlpool 4322525 Manual page 12

WARNING
Electric Shock Hazard
Do not use 2-wire cable with a bare
grounding wire. All current -carrying wires
must be insulated.
Failure to follow these instructions could
result in fire, electrical shock, or death.
To install the power supply cord to the terminal
block screws on the back of the range, per-
form the following steps.
1. Turn off the power supply.
2. If the power supply cord does not have
eyelets installed on the leads, prepare the
leads, as shown in Figure 2-5.
1" (2.5 cm)
Figure 2-5
Preparing The Lead Ends
3. Remove the terminal block cover from the
back of the range, and the brass terminal
nuts that are attached to the knockout (see
Figure 2-6).
Brass
Terminal Nuts
Figure 2-6
Removing The Terminal Block Cover & Nuts
3"
(7.6 cm) Hooked
Lead
Terminal
Block
Cover
4. Attach a U.L.-listed conduit connector to
the knockout opening, but do not remove
the knockout (see Figure 2-7).
Do Not Remove
Knockout
Mounting The Conduit Connector
5. Slide the lead end of the power supply
cord through the conduit connector and
tighten the strain relief clamp. Make sure
that you allow enough slack in the cord so
you can easily connect the lead ends to
the terminal block screws (see Figure
2-8).
6. Remove the grounding link screw from the
range frame (see Figure 2-8).
Grounding Link
Removing The Grounding Link Screw
2-4
Conduit
Connector
Opening
Figure 2-7
Grounding
Link Screw
Figure 2-8