Lp Gas Hook-Up - DCS BGA131 Use And Care Manual

GAS REQUIREMENTS
To hook-up the fittings supplied with the
Professional Side Burner, assemble as shown
in Fig.02. Use joint compound on male
threads only.
Do not use joint compound on the flare end of
the 1/2" NPT to 3/8" flare adapter. Ensure that
the regulator arrow points in the direction of
gas flow-towards the unit, away from the
supply.
Do not forget to place the installer-supplied
gas valve in an accessible location.

LP GAS HOOK-UP

CONNECTION: 1/2" NPT male with 3/8" flare
adapter (included).
OPERATING PRESSURE: 10.0"W.C.
Side Burner uses the LP regulator from
adjoining grill.
Apply joint compound to the threaded end of
the Side Burner gas inlet and tighten the
adapter to the pipe. Assemble the (2) 24"
hoses to the 3/8" flare tee, as shown in Fig.03.
Tighten the regulator hose to the remaining
fitting of the 3/8" flare tee.
Bottom of
131 &132 Burner
To Gas Supply
7
Open Top
Manifold
1/2" Coupling
1/2" Nipple
Regulator
1/2" NPT to 3/8"
Flare Adapter
FIG.02
FIG.03