Sanding/Finishing - Grizzly H8259 Owner's Manual

NOTICE: Only use tap screws or wood screws
with non-tapered heads (Figure 28) to attach the
faceplate to the workpiece. Do NOT use drywall
screws or screws with tapered heads because
these can split the faceplate, or the screws may
snap off during operation.
�����
Figure 28. Correct and incorrect screw types for
mounting faceplate to workpiece.
To mount your workpiece to a backing block:
1. Make the backing block (Figure 29) from
a piece of scrap wood that is flat on both
sides.
Backing
Block
Figure 29. Example of mounting faceplate to a
backing block.
2. Locate and mark the center of both the
workpiece and the backing block.
3. Drill a ⁄ " diameter hole through the center of
1
4
the backing block.
4.
Glue the center of the backing block to the
center of the workpiece (look through the
drilled hole to line up centers), clamp the
backing block to the workpiece, and wait for
the glue to cure according to the manufactur-
er's recommendation.
H8259 10" x 18" Benchtop Lathe
���

Sanding/Finishing

After turning, the workpiece can be sanded, as
shown in Figure 30, and finished (in the same
manner) before removing it from the lathe.
Figure 30. Typical sanding operation.
���������
Wrapping the sandpa-
per completely around
the workpiece will pull
your hands into the mov-
ing workpiece and may
cause injury. Never wrap
sandpaper
���������
around the workpiece!
Whenever sanding or finishing, move the tool rest
holder out of the way to increase personal safety
and gain adequate working room.
completely
-21-