Assembly; Beginning Assembly; Stand - Grizzly G5979 Instruction Manual

SECTION 4: ASSEMBLY

Beginning Assembly

!
Most of your Model G5979 has been assembled
at the factory, but some parts must be assembled
or installed after delivery. We have organized the
assembly process into steps. Please follow along
in the order presented here.
TOOLS REQUIRED: Metric hex key set,
adjustable wrench, Phillips and flat screwdriver.
G5979 Wood Lathe
Disconnect power to the
machine when perform-
ing any maintenance,

assembly

or adjust-
ments. Failure to do this
may result in serious
personal injury.
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Some metal parts may
have sharp edges on
them after they
formed. Please examine
the edges of all metal
parts before handling
them. Failure to do so
could result in injury.
1. Attach a front and rear vertical leg to the top
plate using the
flat washers and
plate so that it fits inside the legs.
2. Repeat the previous step with the other two
vertical legs.
3. Attach the two long horizontal supports to
each of the vertical leg assemblies using the
1
⁄ "-20 x
4
and 1
4. Attach the two short horizontal supports to
each of the vertical leg assemblies using the
1 ⁄ "-20 x
4
1
and
5. Place the stand on a level surface and tight-
en all the nuts using a 14mm wrench.
are

Stand

1 ⁄ "-20 x 3 ⁄ " carriage bolts,
4 8
1
⁄ " nuts. Position the top
4
3
⁄ " carriage bolts,
8
⁄ " nuts.
4
3 ⁄ " carriage bolts,
8
⁄ " nuts.
4
Figure 4. Stand assembled.
1 ⁄ "
4
1
⁄ " flat washers
4
1 ⁄ " flat washers
4
-11-