Maintenance; General; Rust; Lubrication - Grizzly G5979 Instruction Manual

SECTION 7: MAINTENANCE
!
Disconnect power to the
machine when perform-
ing any maintenance,
assembly
ments. Failure to do this
may result in serious
personal injury.

General

Regular periodic maintenance on your Model
G5979 will ensure its optimum performance.
Make a habit of inspecting your machine each
time you use it. Check for the following conditions
and repair or replace when necessary:
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Damaged V-belt.
5. Any other condition that could hamper the
safe operation of this machine.
-20-
or adjust-
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Wear safety glasses
during the entire mainte-
nance process. Failure
to comply may result in
serious personal injury.

Rust

The nonpainted surfaces on the Model G5979
should be protected against rust and pitting.
Wiping the machine clean after every use ensures
that wood dust will not trap moisture against bare
metal surfaces.

Lubrication

All bearings are shielded and permanently lubri-
cated. Simply leave them alone until they need to
be replaced. Do not lubricate them.
The end of the motor shaft has a lube fitting that
requires periodic lubrication. It is very important
not to over lube this fitting; otherwise, dirt and
debris will collect on the motor shaft, causing pre-
mature failure of the pulley mechanism. We rec-
ommend using a few shots of light spindle oil.

V-Belt

Inspect regularly for tension and wear. Check pul-
leys to ensure that they are properly aligned. See
pulley/V-belt sections for proper tension and pul-
ley alignment procedures.

Dust/Chip Removal

Saw dust and wood chips allowed to sit on cast
iron surfaces can trap moisture and cause rust.
Regularly wipe or blow sawdust and chip buildup
of of the lathe unit. This will help reduce the
chance of rust.
G5979 Wood Lathe