Lamp Replacement - American DJ Wave User Instructions

Wave
This fixture is fitted with halogen lamps which are
highly susceptible to damage if improperly handled.
Never touch the lamps with your bare fingers as the
oil from your hands will shorten lamp life. Also, never
move the fixture until the lamps have had ample time
to cool. Remember, lamps are not covered under war-
ranty conditions.
Caution:
Always replace with the exact same type lamp, unless oth-
erwise specified by an authorized American DJ
with anything other than the specified part can damage your unit and
will void your manufactures warranty.
Warning:
If you continue to blow either the lamp or the fuse, STOP
using the unit. Contact customer support for further instructions, you
may have to return the unit for servicing. Continuing to use the unit
may cause serious damage.
Fuse Replacement: Locate and remove the unit's power cord. Once
the cord has been removed located the fuse holder located inside the
power socket. Insert a flat-head screw driver into the power socket
and gently pry out the fuse holder. Remove the bad fuse and replace
with a new one. The fuse holder has a built-in socket for a spare fuse
be sure not to confuse the spare fuse with active fuse.
Lamp Replacement: Caution! Never attempt to change the lamp
while the fixture is plugged in. Always disconnect the main power
and allow the unit ample time to cool before attempting to replace
the lamp.
1. Be sure to follow the proper handling procedures that deal with
the lamp.
2. Remove the thumb screws on the top of the unit.
3. After removing the thumb screws, pull off lamp protective cover.
4. Carefully remove the old lamp by pushing in on one end of the
lamp socket. Pushing the metal ends will not do any good, you
must push either of the the white ceramic sockets toward
the metal piece (away from the lamp), and then slide the
lamp out (See next page). Remove the lamp and discard it in the
trash.
5. Replace the lamp with an exact match and reassemble in reverse
order.
American DJ - www.americandj.com - Wave Instruction Manual Page 11
© ®

Lamp Replacement

technician. Replace
®
Wave
Ceramic sockets
Push either of the ceramic sockets away from the lamp, then
pull that side of the lamp out first.
American DJ - www.americandj.com - Wave Instruction Manual Page 12
© ®
Lamp Replacement