Set Up Instructions - Stamina Elite TOTAL BODY Owner's Manual

SET UP INSTRUCTIONS

Place the TOTAL BODY RECUMBENT BIKE in the area where it will be used. It is recommended that the
TOTAL BODY RECUMBENT BIKE be placed on an equipment mat. The TOTAL BODY RECUMBENT
BIKE is approximately 49 5/8 inches long x 23 5/8 inches wide x 48 5/8 inches tall. (These dimensions may
vary up to one inch.) An area 4 feet wide x 6 feet long is required for safe operation of the TOTAL BODY
RECUMBENT BIKE. Make sure that adequate space is available for access to and passage around the
TOTAL BODY RECUMBENT BIKE.
LEVELING: Place the TOTAL BODY RECUMBENT BIKE on a flat surface and equipment mat to set it
on the floor without rocking. Adjust the STAND(65) under the REAR FRAME(2) to get more
support for the base of the TOTAL BODY RECUMBENT BIKE.
MOVING: The TOTAL BODY RECUMBENT BIKE has a pair of WHEELS(76) on the FRONT
STABILIZER(8). Lift up the REAR STABILIZER(9) to move the TOTAL BODY RECUMBENT
BIKE.
Equipment Mat
FUNCTION INSPECTION:
Visually inspect the TOTAL BODY RECUMBENT BIKE to verify that assembly is as shown in the above
illustration. Check the function of the TOTAL BODY RECUMBENT BIKE. Turn the pedal and then handlebar
slowly through one complete revolution to verify that the drive train functions properly. Adjust the TENSION
KNOB(21) and verify that it functions properly.
CAUTION: Locate and read the CAUTION LABEL(122) on the TOTAL BODY RECUMBENT BIKE. Make
sure that all users read the CAUTION LABEL(122).
Loosen the NUT(M8x1.25) until they touch the
LEVELING STAND(65). Adjust the LEVELING
STAND(65) for leveling. Tighten the NUT
(M8x1.25) securely against the REAR FRAME(2)
to lock the stand in position.
11
Nut