Stamina AVARI Upright Bike Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
STEP 5
Refer to the inset drawing. Pull the ends of the TENSION CABLE(22) and SENSOR WIRE(26) out of the
MAIN FRAME(1). To connect the TENSION KNOB(23) to the TENSION CABLE(22):
a. Turn the TENSION KNOB(23) counterclockwise as far as it can go, so the CABLE END extends out of
the METAL FITTING as far as possible.
b. Connect the CABLE END of the TENSION KNOB(23) to the SPRING HOOK on the end of the TENSION
CABLE(22).
c. Pull on the Cable of the TENSION KNOB(23) firmly so that enough cable is available to allow the METAL
FITTING go through the slot in the top of the BRACKET. Then insert the METAL FITTING into the hole at
the end of the slot in the BRACKET.
d. Adjust the TENSION KNOB(23) and verify that the SPRING HOOK moves when the TENSION KNOB(23)
is adjusted.
STEP 6
Connect the CONNECTION WIRE(25) to the SENSOR WIRE(26). Insert the UPRIGHT(4) into the MAIN
FRAME(1) and secure with BUTTON HEAD BOLTS(M8x1.25x15mm)(41), LOCK WASHERS(M8)(56),
and ARC WASHERS(M8)(55).
9
Meijer.com
METAL FITTING
CABLE END
BRACKET
SPRING HOOK