Support Brackets; Collector - Grizzly G1028Z/G1029 Instruction Manual

Support Brackets

There are two lower collector support brackets
and one upper bag support bracket. Attach the
collector brackets to the top edge of the base
plate using four (4) 5 ⁄
16
ed, as shown in Figure 5.
Figure 5. Mounting brackets to base.
-12-
"-18 x 1 ⁄ " hex bolts provid-
2

Collector

The collector attaches to each support bracket.
The inside of the collector is funnel shaped and
directs the air around in a cyclone motion. Make
sure that the inside taper (funnel) is faced down-
ward and the collector inlet faces toward the col-
lector body.
Secure the front support bracket to the collector
5
with two (2) ⁄ "-18 x
16
Before securing the rear support bracket to the
collector, line up the upper bag support bracket
bolt holes with the collector support bracket bolt
holes and the collector. Secure with two (2)
3
18 x ⁄ " bolts provided, as shown in Figure 6.
4
Figure 6. Mounting collector to brackets.
G1028Z/G1029 Dust Collector
3
⁄ " hex bolts provided.
4
5 ⁄ "-
16