Table of Contents
Advertisement
Outlet
Components and Hardware Needed:
Metal "Y" Outlet ................................................1
5
Flange Bolts
⁄
"-18 x
16
Rubber Gasket ..................................................1
Tools Needed:
Wrench or Socket 12mm....................................1
To install the metal "Y" outlet:
1.
Place the rubber gasket around the impeller
outlet rim as shown in Figure 9.
Figure 9. Placing rubber gaskets over outlet.
2.
Secure the metal "Y" outlet in place with the
flange bolts (Figure 10).
Figure 10. Metal "Y" outlet attached
to the impeller.
-14-
1
⁄
"....................................8
2
Canister Support
Qty
Components and Hardware Needed:
Base ..................................................................1
Canister Supports ..............................................2
Flange Bolts
Tools Needed:
Wrench or Socket 12mm....................................1
To install the canister support:
1.
Place the canister support over the holes on
the base edge (Figure 11).
Figure 11. Canister support attached to base.
2.
Secure the canister support in place with 2
flange bolts.
3.
Repeat steps 1 & 2 for the second brace.
5
⁄
"-18 x
1
⁄
"....................................4
16
2
G0562 3 HP Dust Collector
Qty
Advertisement
Table of Contents
