Samsung SCV-3081 User Manual page 30

setup
Use the Function Setup switch to move to a desired letter and select the letter
by pressing the switch. Repeat this to enter multiple letters. You can enter
up to 15 letters.
Enter a title, move the cursor to 'POS'
and press the Function Setup switch. The
entered title appears on the screen. Select
the position to display the title on the screen
by using the Function Setup switch and
press. When the position is determined,
select 'END' and press the Function Setup
switch to return to the SPECIAL menu.

M
When the CAM TITLE menu is 'OFF', no title will be displayed on the monitor screen even if you
enter one.

Only English is available in the mode.

If you move the cursor to CLR and press the Function Setup switch, all the letters are deleted.
To edit a letter, change the cursor to the bottom left arrow and press the Function Setup switch.
Move the cursor over the letter to be edited, move the cursor to the letter to be inserted and then
press the Function Setup switch.
SYNC : In areas where the supply is
at 60Hz(NTSC), 50Hz(PAL), you can
synchronize the output phase of multiple
cameras using the power synchronization
function (Line-Lock) without using a
synchronization signal generator.
- INT : Internal Synchronization Type
- LL : Power Synchronization Type, Line-lock
Press the Function Setup switch.
You can select a desired phase from 0 to 359 when select 'phase'.

M When using AC power at 60Hz(NTSC), 50Hz(PAL) frequency, you can use the LL type
synchronization.

When the power is DC 12V, the SYNC menu is fi xed to the 'INT' mode.

If the VPS is set to ON, synchronization is fi xed to INT.
30_ setup
FRONT DOOR
SYNC
PHASE
Press SET to Return
0