Table of Contents
Advertisement
RETURN : Select this to save the changes in the EXPOSURE menu and return to
the SETUP menu.
If you set the Function Setup switch to 'AUTO' mode, You can adjust the brightness by
M
increasing or decreasing the limit value. (x2~x512)
Note that the higher the SENS-UP level, the brighter the screen, but the more likely it is that an
after-image will appear.
Although Noise, Spots, and Whitish symptoms may occur in SENS-UP operation when the
sens-up level is increased, this is normal.
WHITE BAL (WHITE BALANCE)
Use the White Balance function to adjust the screen color.
1.
When the SETUP menu screen is displayed, select 'White Bal.' by using the
Function Setup switch so that the arrow
indicates 'White Bal.'.
2.
Select a desired mode using the Function
Setup switch.
Select one of the following 5 modes, as
appropriate for your purpose.
ATW : Select this when the color temperature is between 1,700°K and 11,000°K.
OUTDOOR : Select this when the color temperature is between 1,700°K and
11,000°K.(sodium light inclusion)
Select this When the color temperature of environment surrounding
the subject is out of the control range (e.g. clear sky, or sunset)
INDOOR : Select this when the color temperature is between 4,500°K and 8,500°K.
MANUAL : Select this to fi ne-tune White
Balance manually. Set White
Balance fi rst by using the ATW
or AWC mode. After that switch
to MANUAL mode, fi ne-tune the
White Balance and then press the
Function Setup switch.
AWC SET : To fi nd the optimal luminance level for the current environment,
point the camera towards a sheet of white paper and press the
Function Setup switch. If the environment changes, readjust it.
MAIN SETUP
1.LENS
2.EXPOSURE
3.WHITE BAL
4.BACKLIGHT
WB MANUAL
RED GAIN
BLUE GAIN
Press SET to Return
English_21
DC
ATW
OFF
235
245
Advertisement
Table of Contents
