Read Me First - Shure SC User Manual

ENGLISH
... A quick guide to operating your Shure wireless microphone system.
RECEIVER CONNECTIONS
1. Attach the antennas to the receiver antenna connectors.
2. Connect the receiver audio output to the sound system, using an audio
cable.
3. Connect the ac power adapter to the receiver power connector, then
plug into an ac outlet.
TRANSMITTER CONNECTIONS
1. Open the transmitter battery compartment and insert a fresh 9-volt
alkaline battery. Observe proper battery polarity ( " +/–" ).
2. On a body-pack transmitter, connect the microphone or WA302
instrument cable to the 4-pin connector on the transmitter.
OPERATING THE SYSTEM
1. Press the receiver POWER switch. The green POWER indicator on the
receiver will illuminate.
2. Set the transmitter POWER switch to the ON position. The green
POWER indicator on the transmitter will illuminate.
3. Observe the RF level LEDs on the receiver. When the transmitter is in
use, one of the LEDs will illuminate, indicating received RF signal
strength (a stronger signal will illuminate a higher numbered LED). If
none of the RF LEDs are lit, the transmitter may be too far from the
receiver, reflective obstacles may be interfering with the signal, or the
transmitter/receiver frequency selector switch settings may not match.
4. Observe the AUDIO level LEDs on the receiver while someone talks,
sings, or plays a musical instrument. The green LEDs should light, with
the yellow LEDs flickering occasionally to indicate audio signal peaks.
Refer to the "Setting Audio Level" section if the yellow LED is always
on, or never turns on.
5. Adjust the receiver VOLUME control until the output level is compatible
with the mixer or amplifier input.
IMPORTANT: Every wireless microphone installation is a unique situation,
and can present a variety of problems. Never attempt a live performance
without first conducting a "walkthrough." If major changes (intercoms,
furniture, scenery, etc.) have been made since the walkthrough, check the
wireless microphone operation again – as close to performance time as
possible.
FOR ADDITIONAL INFORMATION, CONSULT THE SETUP AND
INSTALLATION SECTION OF THIS GUIDE.

READ ME FIRST!

– 1 –
ENGLISH