Section 8: Wiring; Electrical Safety Instructions - Grizzly G3358 Owner's Manual

electrical safety instructions

1. printed information. the electrical
information included in this section is current
at the time of printing. however, in the spirit
of improvement, we may make changes to
the electrical system of future machines.
study the photos and diagrams in this
section carefully. if you notice differences
between your machine and these diagrams,
call technical support at (570) 546-9663 for
assistance.
2. shocK hazard. disconnect the power
from the machine before servicing electri-
cal components. touching electrified parts
will result in personal injury including but
not limited to severe burns, electrocution, or
death.
3. motor Wiring. the motor wiring shown
in these diagrams are current at the time of
printing, but it may not match your machine.
Always use the wiring diagram inside the
motor junction box.
g3358 Milling/drilling Machine

section 8: Wiring

NoTICE
the photos and diagrams included in this
section are best viewed in color. you can view
these pages in color at www.grizzly.com.
4. circuit reQuirements. you Must fol-
low the circuit reQuirements section
on page 9. if you are unsure about the
wiring codes in your area or you plan to
connect your machine to a shared cir-
cuit, consult a qualified electrician.
5. grounded circuit. electrocution or fire
could result if the machine is not grounded
and installed in compliance with electrical
codes. Compliance Must be verified by a
qualified electrician.
6. eXperiencing difficulties. if at any
time you are experiencing difficulties under-
standing the information included in this
section, contact our technical support at
(570) 546-9663.
-35-