Mounting And Connecting Tips - XTZ 93 WMT User Manual

The correct height
Cables
Finally

Mounting and Connecting tips

Mounting
alternatives
Connect using the
correct phase
Overload
The initial playing
time
reflections from the side walls. By angling the
loudspeakers inwards, you decrease unwanted
reflections and thus you get a better stereo
perspective.
If the loudspeakers are small, they should be placed
on stands or tilted so that they are on the same
level as the ears.
Try to keep them as short as possible. By its
electrical parameters, a long conductor will have a
bigger influence on the sound than a short one. It
may also work as an antenna and thus receive
various signals, that may become a constant noise
in an active subwoofer.
Make sure that all connections are clean and not
oxidated. All connections should be mechanically
stable, both power, signal and loudspeaker cables.
Signal cables should be separated from other
cables.
Please remember that good sound is a matter of
taste, so you have to experiment to obtain it. We
wish you the best of luck!
Normally the XTZ 93 WMT is placed standing by a
wall. The wall behind and the wall beside the
loudspeaker have influence on both the bass level
and the bass characteristics, so please be patient
and try different distances to the rear and side
walls.
Always connect using the correct phase, from the
+-pole on the amplifier to the +-pole on the
loudspeaker and corresponding for minus (-).
At high load during extensive time periods, there is
always the risk of overloading the driver and
amplifier.
It takes about 50 to 100 hour of initial playing time,
for the driver to sound optimal. During this time,
the speaker may be used normally.
If you by accident connect the other way,
there is no risk of damage. However, the
sound will not be correct, especially in the
lower frequencies.
All loudspeakers have a limited patience
for high power, so be careful not to play
extremely loud and not to increase trebble
or bass settings to much.
By increasing the bass or treble from 0 to
max you will increase the power by about
16 times.
Page: 7