Table of Contents
Advertisement
Client PC Description
Client PC IP Addresses
Client PC Service
Protocol
Port Range
Apply Changes
Reset
Click <Apply Changes> at the bottom of the screen to save the above configurations. You can
now configure other advance sections or start using the router (with the advance settings in place)
The description for this client PC rule.
Enter the IP address range that you wish to apply this
Access Control rule. This is the user's IP address(es)
that you wish to setup an Access Control rule. You can
select a range of users simply by inputting the starting
users' IP address and the last user's IP address in the
appropriate boxes. If you want to select only one user
then input the user's IP address in both boxes.
Note: You need to give your LAN PC clients a
fixed/static IP address for the Access Control rule to
work properly.
You can block the clients from accessing some
Internet services by checking the services you want
to block.
This allows you to select UDP, TCP or both
protocol type you want to block.
You can assign up to five port ranges. The router
will block clients from accessing Internet services
that use these ports.
Click "Apply Changes" to save the setting.
Click "Reset" to clear all fields.
Advertisement
Table of Contents
