Table of Contents
Advertisement
6.
Plug the XPower Charger 2 cord into a
standard 115 volt AC outlet.
7.
As the battery charges, the green Power
light and red Charging light turn on.
CAUTION
If the green Power light turns off and the red
Charging light turns on, immediately
disconnect the clips from the battery
terminals.
The unit has detected an output short circuit
or reverse polarity on the DC connection.
Check the connection.
8.
When fully charged, the red Charging
light turns off and the green Power light
remains on. The recharge time will vary
based on the capacity and discharge state
of your battery.
9.
Once the battery is fully charged,
disconnect the AC cord, remove the
NEGATIVE (BLACK) charger clip from
the cable, and then remove the
POSITIVE (RED) clip from the battery
terminal.
20
Advertisement
Table of Contents
