10. affix the wide foam strip around the outside
top rim of the collector, as shown in figure
17.
figure 17. installing wide foam strip.
11. trim the excess foam strip so the ends come
together evenly, as shown in figure 18.
figure 18. trimmed foam strip.
12. secure the narrow foam strip around the out-
side bottom rim of the collector and trim the
excess, as shown in figure 19.
Collector hooks
narrow Foam strip
figure 19. trimmed foam strip and collector
hook locations.
-16-
13. g0562z/g0562zp only:
a. install the canister handle onto the
top of the canister filter by tightening
the bolt against the flat of the shaft
(see figure 20).
Flat
figure 20. installing canister handle.
b. place the canister filter on top of the
collectors.
c. position the metal belt clamp around
the bottom of the canister and latch it
so it evenly compresses against the
foam strip (see figure 17).
figure 21. installed canister.
d. repeat a–c for the other canister.
Model g0562z/zp, g1030z2/z2p (Mfg. 11/11+)