Air Shutter Setting; Media Options; Verify Performance Of Appliance - Heat & Glo XLR-PLUS-N-AU Owner's Manual

G. Air Shutter Setting
Air shutter settings may be adjusted by a qualifi ed install-
er at the time of installation. The air shutter is set at the
factory for minimum vertical vent run. Adjust air shutter for
longer vertical runs. See Figure 14.3.
• Loosen the 1/4 in. screw.
• Twist shutter to adjust
• Shutter may be open for longer horizontal vent runs.
• Do not close the air shutter more than 16 mm for NG or
80 mm for LP. Note: the air shutter should be fully open
when using butane.
• Tighten the screw.
NOTICE: If the fl ames appear to be orange, open the air
shutter to prevent residue buildup on the glass.
Figure 14.3 Air Shutter
Shutter Settings
Logs
NG 13 mm
Propane Full Open
Butane Full Open
Glass Media Fiber Stones
5 mm 6 mm
10 mm 13 mm
Full Open Full Open
Heat & Glo • XLR-PLUS-N-AU, XLR-PLUS-PB-AU • 2264-900 Rev. D • 6/11
H. Media Options
Unit ships without a media option. Available approved
media options are:
• MEDIA-AMBER
• MEDIA-BLACK
• MEDIA-CLEAR
• MEDIA-COBALT
• MEDIA-BK2-GEMS
• MEDIA-WH2-GEMS
• MEDIA-GEMS
• XLR-LOGS
• MEDIA-STONES-2
I. Verify Performance of Appliance
1. Verify pilot sparks, pilot lights, pilot stops sparking, and
the main burner turns "ON" by turning wall control "ON".
2. Turn fi replace "OFF". Verify that the both the pilot and
burner turn "OFF".
3. Repeat Step 1 above.
4. With the burner "ON" remove the green wire connected
to the gas valve after the second audible "beep" from
the control module is heard. The main burner should
shut off. Turn appliance "OFF".
5. Reattach the green wire to the valve and turn "ON" the
fi replace. The main burner should light after the second
audible "beep" from the control module is heard.
6. With the burner "ON" remove orange wire both the main
burner and pilot should go out.
7. Turn fi replace "OFF" and reattach orange wire to the
valve.
8. Repeat steps 1 & 2 to ensure proper functionality of
appliance.
53