Test Run - Grizzly G0612 Owner's Manual

2.
Slip the bag clamp over the collection bag,
then attach the collection bag to the chute
and clamp it as shown in Figure 20.
Bag
Clamp
Figure 20. Attaching the dust collection bag.

Test Run

Before you begin operations, do Steps 1-7 below
to make sure your jointer is running properly.
Loose hair and cloth-
ing could get caught in
machinery and cause
serious personal inju-
ry. Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Projectiles thrown from
the machine could cause
serious eye injury. Wear
safety glasses during
assembly and operation.
To test run your jointer:
1.
Read the entire instruction manual first!
-16-
2.
Make sure the cutterhead guard fully covers
the cutterhead.
3.
Make sure all tools and foreign objects have
been removed from the machine.
4. Review SECTIONS 1 and 2 (SAFETY and
CIRCUIT REQUIREMENTS) on Pages 5-
8 and connect your machine to the power
source.
5. Turn the jointer ON.
— The jointer should run smoothly with little or
no vibration.
— Immediately stop the jointer if you suspect
any problems. Refer to Pages 31 & 32 to
troubleshoot and fix any problems before
starting the jointer again.
6. Turn the jointer OFF, then remove the safety
key from the ON/OFF paddle switch.
7. Lift the paddle switch to the ON position.
—If the jointer motor does not start, then the
safety key is working properly and you
have finished the test run.
—If the jointer motor starts when the
safety key is removed, IMMEDIATELY
DISCONNECT THE JOINTER FROM THE
POWER SOURCE. Refer to Pages 32 &
33 to troubleshoot the problem.
—If you still cannot solve this or any other
problem that arises during the test run, call
Grizzly Tech Support at (570) 546-9663.
G0612 6" Jointer