Dmx Linking; Dmx Modes; Protocol Connectivity - Iluminarc Ilumipod Inground Tri-3 IP Optic 25 RGB User Manual

Ilumipod inground tri-3 ip optic 25 rgb
Hide thumbs Also See for Ilumipod Inground Tri-3 IP Optic 25 RGB:
Table of Contents

Advertisement

Installation
The Ilumipod
Inground Tri-3 IP
Optic 25 RGB
products must be linked
using DMX cable in a
daisy chain (serial)
fashion. To comply with
the EIA-485 standard, no
more than 32 products
should be connected on
one daisy chain without
using a DMX optically-
isolated splitter. Doing
otherwise may result in
deterioration of the digital
DMX signal.
USITT
recommends
limiting the total
length of the DMX cable
(from the first
product/controller to the
last product) to
300–455 m
(985–1,500 ft).
Disconnect the
product from the
AC power before
opening it.
The signal cable
must match or
exceed the
electrical characteristics
of the Belden® 9841
cable for EIA RS-485
applications. You may
also use CAT5, 5e, or
CAT6 LAN cable.
8

DMX Linking

You may link the Ilumipod Inground Tri-3 IP Optic 25 RGB to a DMX controller using a
standard DMX serial connection. If using other DMX products compatible with the Ilumipod
Inground Tri-3 IP Optic 25 RGB, you can control each individually with a single DMX
controller.
If you are not familiar with the DMX standard, or if you need information about the DMX
cables needed to link the Ilumipod Inground Tri-3 IP Optic 25 RGB to a DMX controller, you
may download the DMX Primer document from the ILUMINARC® website at
http://www.iluminarc.com/reports/dmx-primer.

DMX Modes

The Ilumipod Inground Tri-3 IP Optic 25 RGB uses the standard DMX data
connection for its ARC 1, ARC 1 + D, ARC FULL, and SOLID. Refer to the
Introduction
chapter for a brief description of these modes and the
to learn how to configure the Ilumipod Inground Tri-3 IP Optic 25 RGB. The
Values
section will give you detailed information regarding the above-mentioned
DMX modes.
DMX Mode
ARC FULL
ARC 1

Protocol Connectivity

The Ilumipod Inground Tri-3 IP Optic 25 RGB uses the USITT DMX 512 Protocol.
The procedure below illustrates the recommended connection method.
DMX Address
DMX Mode
506
SOLID
ARC 1 + D
510
Ilumipod Inground Tri-3 IP Optic 25 RGB User Manual Rev. 5
Operation
chapter
DMX Address
512
509
DMX

Advertisement

Table of Contents
loading

Table of Contents