Replacing The Hyperhepa Filter (F2); Discarding Used Filters; Chapter 7 - Maintenance; Cleaning The Housing - IQAir HealthPro Compact User Manual

Chapter 7 – Maintenance
6.5 Replacing the HyperHEPA® Filter (F 2)
1. Open the locking arms, making sure they
are fully extended outward. For details,
refer to section 6.3.
4. Turn the frame over so it is upside down.
TOP TOP
7. Dispose of the used filter by placing it into
the plastic bag in which the new filter is
supplied (see section 6.6).

6.6 Discarding Used Filters

Used filters can normally be put into the regular household trash for disposal.
If the system may have been exposed to potentially hazardous substances, the filters may have to be disposed of
as hazardous waste. Please refer to local regulations and laws for proper disposal.
Chapter 7 – Maintenance

7.1 Cleaning the Housing

•
Unplug the IQAir system before attempting to clean it.
•
Use a soft and clean cloth for cleaning.
•
For water soluble stains, use a window cleaning fluid.
•
For the removal of tough, non water soluble stains, use a silicon spray.
•
Do not use any solvents or any organic cleaning fluids.

7.2 Maintenance-Free Fan

The IQAir system is equipped with a maintenance-free fan motor.
24
Diffuser
Frame 2
2. Opening the arms will release the top
housing modules. Removing the dif fu ser
will reveal the HyperHEPA filter inside
Frame 2.
5. With the palm of the hand, press down
on the filter to loosen the filter from the
frame.
TOP TOP
8. Turn the frame over (right side up again)
and insert the new filter. Ensure that the
arrows on the filter label point upward.
The Label "this way up" should be visible
when installed properly. Re-install four
filter clamps.
Frame 2
3. Remove frame 2 containing the HyperHEPA
fil ter.
6. Lift the frame from the filter.
Frame 2
9. Put frame 2 back into the housing and
reposition the diffuser. For closing refer to
section 6.3.
10.
HyperHEPA
filter