Replacing The Hyperhepa® Filter (Filter 2); Discarding Used Filters; Chapter 7 - Maintenance; Cleaning The Housing - IQAir HealthPro 150 User Manual

6.5 Replacing the HyperHEPA® Filter (Filter 2)
1. Open the locking arms, making sure they
are fully extended outward. For details,
refer to the section 6.3.
4. Turn the frame upside down.
7. Dispose of the used filter by placing it into
the plastic bag in which the new filter is
supplied (see the section 6.7).

6.6 Discarding Used Filters

Used filters can normally be put into the regular household trash for disposal. If the system may have been exposed
to potentially hazardous substances the filters may have to be disposed of as hazardous waste. Please refer to local
regulations and laws.
Chapter 7 – Maintenance

7.1 Cleaning the Housing

•
Unplug the IQAir® system before attempting to clean it.
•
Use a soft and clean cloth for cleaning.
•
For water soluble stains, use a window cleaning fluid.
•
For the removal of tough, non water soluble stains, use a silicon spray.
•
Do not use any solvents or any organic cleaning fluids.

7.2 Maintenance-Free Fan

The IQAir® system is equipped with a maintenance-free fan motor.
Diffuser
Frame 2
2. Opening the arms will release the top
housing modules. Removing the dif fu ser,
will reveal the HyperHEPA® filter inside
Frame 2.
5. With the palm of the hand, press down on
the filter and loosen the frame.
TOP TOP
8. Turn the frame around and insert the new
filter. Ensure that the arrows on the filter
label point upward.
Chapter 7 – Maintenance
Frame 2
3. Remove Frame 2 containing
HyperHEPA® fil ter.
6. Lift the frame from the filter.
Important:
After a filter has
been
the
Frame 2
monitor must be
reset (see section
4.4.8).
9. Put frame 2 back into the housing and
reposition the diffuser. For closing refer to
the section 6.3.
HyperHEPA®
filter
the
replaced,
filter life
25